Edvinas avatar
Written by Edvinas
Updated over a week ago

This function will allow to find DTCs (“Diagnostic Trouble Codes” or Fault Codes) that exist in the control unit. To access it follow the instructions:

  • Press the

    button to open control units list.

  • Select the needed control unit by

    tapping on it.

  • Press

    "Faults" button.

  • by pressing on the fault you can

    expand additional information such as the fault codes, status.

  • By pressing

    on the Google icon you will be located to the search for the information about fault.

  • Press

    button to send the log of the found faults.

  • Press

    icon to change the language of displayed faults.

  • Select

    the language.

  • The language has been changed.

  • Press

    button to delete the faults (Some faults cannot be cleared as internal processor faults and the control unit may explicitly refuse or may just still display the fault after a clearing attempt. Be aware, clicking on clear codes does not fix the problem that caused the fault! DTCs should only be erased after correcting the condition(s) that caused them in the first place. There is no way to erase individual DTCs while leaving others alone. In some cases, the ignition must be cycled after clearing codes but before performing certain functions such as basic settings).

  • Press

    button to refresh/reload the faults of control unit.

Did this answer your question?