Skip to main content
Gateway coding
Edvinas avatar
Written by Edvinas
Updated over a week ago

The gateway serves as the information bridge between various in-car communication networks. It also serves as the vehicle central diagnostic interface (It will allow you to install or uninstall the control units in the gateway). Mostly, the gateway has appeared in vehicles from 2005 manufacturing years. To access the function follow the instruction:

  • Connect to your vehicle by pressing

    .

  • Open the list of control units by pressing

    .

  • Open the gateway by pressing

    .

  • Select the needed gateway by tapping on it

    .

  • Apply the selection by pressing

    .

  • You will now see the displayed control units. The marked ones are currently installed in your vehicle and vice versa

    .

  • Control units that are not installed in your vehicle

    .

  • To Install/Uninstall need to Mark/Unmark the control units and apply by pressing

    .

You can change the gateway by pressing "Change >"

Newer cars have the control units which do have the control units inside them.

  • Select the needed gateway by tapping on it, and apply by pressing

    .

  • The marked ones are currently installed in your vehicle and vice versa. To Install/Uninstall need to Mark/Unmark the control units and press "CODE" to finish edition.

Did this answer your question?