Connect to your vehicle by pressing

.

Open the list of control units by pressing

.

Select the needed control unit by tapping on it

.

Open the "Faults" by pressing

.

By pressing

on the fault you can expand additional information as fault code and status which is in the marked zone

.

By pressing

on the Google icon you will be located to the search for the information about the fault.

You can change the language by pressing

.

You will be able to delete the faults in the control unit by pressing

. (Some faults cannot be cleared as internal processor faults and the control unit may explicitly refuse or may just still display the fault after a clearing attempt. Be aware, clicking on clear codes does not fix the problem that caused the fault! DTCs should only be erased after correcting the condition(s) that caused them in the first place. There is no way to erase individual DTCs while leaving others alone. In some cases, the ignition must be cycled after clearing codes but before performing certain functions such as basic settings).