In order to perform the automatic fault scan of vehicle control units follow the instructions below:
In the marked zone
indicators shows in which part of the system fault was found:
- the problem(s) was detected in the engine control unit.
- the problem(s) was detected in the ABS (anti-lock braking) system of the car.
- the problem(s) was detected in the airbag system of the car.
- the problem(s) was detected in the steering column system of the car.
- the problem(s) was detected in other control units.
Marked zone
display already scanned control units in the form: Scanned/All units.
Indicator
displays which control unit is in the scanning mode at the moment.
Indicator
shows the amount of found problems/faults.
You can cancel the scanning by pressing
.
In the marked zone
, you will find the number of problems/faults and by swiping up, you can clear all the faults.
Passive - faults that can be cleaned after reading the trouble codes without changing car parts. Passive faults warn about the bigger issues later. Active - faults are faults which can't be cleaned without fixing or changing car part.