Basic settings are used to calibrate steering angle sensor, AC flap motors, etc: the control module may try to perform various calibrations in basic settings mode.

Follow the steps below on how to access the Basic settings:

  • Connect to your vehicle by pressing

    .

  • Open the list of control units by pressing

    .

  • Select the needed control unit by tapping on it

    .

  • Open Basic settings by pressing

    .

  • In the marked zone

    , you can change the channels by swiping to the left or right.

  • You can enter the channel number by pressing

    .

  • Start the calibration by sliding

    .

  • Stop the calibration by sliding

    .

WARNING! Basic settings are only for professional use. We recommend to not experiment or test functions without necessaries. To fix consequences can be required dealer or transport electrician.

Did this answer your question?