Basic settings UDS
Edvinas avatar
Written by Edvinas
Updated over a week ago

Basic settings are used to store new calibration values to the control unit, for example: steering angle sensor, AC flap motors, Brake pads start/end lining change modes. To access this function follow the instructions:

  • Press the button

    to open control units' list.

  • Select the needed control unit by

    tapping on it.

  • Press

    "Basic settings" button.

  • Select

    the setting from the list.

  • sometimes the value of setting may be selected

    . Normally nothing is needed to change here. Enough to start the process.

  • Press and hold

    button to start the process of basic setting (Basic settings are only for professional using. We recommend to not experiment or test functions without necessity. A dealer or a transport electrician might be required to revert the settings back).

Did this answer your question?