Basic settings are used to store new calibration values to the control unit, as examples: steering angle sensor, AC flap motors, Brake pads start/end lining change modes. To access this function follow the instruction:

  • Connect to your vehicle by pressing

    .

  • Open the list of control units by pressing

    .

  • Select the needed control unit by tapping on it

    .

  • Open Basic settings by pressing

    .

  • Select the needed value by tapping on it

    .

  • Sometimes the values of settings could be selected. Normally, nothing is needed to change here. Enough to start the process by sliding

    .

  • Stop the calibration by sliding

    .

WARNING! Basic settings are only for professional use. We recommend to not experiment or test functions without necessaries. To fix consequences can be required dealer or transport electrician.

Did this answer your question?